One thing you either might have to watch out for or embrace is something I call Garden Creep.
This is the ability of certain gardens, let alone the plants in them, of slowly growing and spreading or even multiplying over time.
Any dedicated gardener can explain to you the visible symtomology of the disease. New garden growths appear almost randomly at times as new outbreaks of gardens pop up in sometimes rather unexpected corners and sections of the area.
This problem is also seen in certain plants as well. When they have managed to obtain a foot hold in an area, where the available space for them, is inadequate for their realistic size. You will find these plants spilling outwards or upwards into space they were never intended to occupy. This causes constant problems for entryways & walkways, as well as air space occupiers like power lines. These planbts then have to constantly attacked and kept back within their territory, often at great cost in time and money to their garden owner.
Lawn areas and sometimes even pathways in it's way are encompassed and/or swallowed up. It even can escape from your area onto and around footpaths and along road verges.
It appears I reckon to be a possibly viral disease that affects both the gardens and their gardeners alike.
It means that these garden areas extend over a period into every little space they can infect and take over, sometimes far outside the originally intended boundaries of the initial garden/s.
-----------
The Bare Bones Gardener is a qualified Horticulturist and a qualified Disability Services Worker. He hates spending money on stuff which doesn’t live up to the promises given. So he looks for cheaper, easier, simpler or free ways of doing the same thing and then he passes these ideas on to others.
Garden Blog -
Tags: Garden, Gardening, Plant Disease, Plants
With the old familiar variety of garden hoses as well as black Poly irrigation systems, there are two major problems that occur along the length of the hose or pipe, one is cracking and/or splitting of the hose/pipe and the second problem is the familiar kinking of the hose/pipe. So what can you do about it besides going out and buying a new hose or roll of poly' pipe? Well there is at least one repair method that should help with either problem. Without the cost and problems of putting expensive joiners into your watering system.
Split Hoses/Pipes
What do you do once your garden hose or irrigation pipe has developed a crack or split after your son has mowed over it or you've managed to drive over it once too often?
With either type of system, you could cut out the section of the damaged hose or pipe and put in a joiner, but sometimes this is impractical or impossible. Then why not look at repairing it instead of replacing it. Use the same method as you would for a kinked hose. Which is listed below.
Kinking Hoses/Pipes
Once a garden hose or irrigation pipe has jack-knifed back on itself at a particular spot, it will continue to do so for the life of the hose/pipe. This is because it has become weakened at that point. Again you have the option to cut out the weakened area and join the remaining parts of the hose. Or you will have to look at repairing the weakened area to stop it kinking in future, you can do this by bracing the weakened area/s by the following method . . .
What you will need to repair split/kinked hoses or irrigation pipes
An excess section of garden hose or irrigation pipe A Sharp knife or blade Container of hot water Measure and cut off a small section of hose/pipe, approximately three inches long, or as long as is needed to cover over the weakened or broken area. Cut this section down its length on one side only.
Soften the hose or pipe section in hot water. Open it up and wrap this like a bandage around the weakened section of hose/pipe.
This acts like a splint over the weak area, strengthening it so that at that point it will not kink or fountain out water anymore.
If you are repairing a split area of the hose you may have to look at sealing the hose with something like a silicon sealant. But you will find that simply putting the hose splint will greatly reduce and/or stop the leak.
The hose or pipe splint will not move off of the weakened or split area because it rehardens fairly quickly as it cools, this tightens its grip over the weak part of your hose/pipe.
Repeat this procedure for other areas that are split or are prone to kink of the garden hose or irrigation pipe that you are using.
So if that garden hose or irrigation system of yours is split in one or more places or is kinking all the time, and it is frustrating you no end, then do something other than throwing it out. Either repair it or at least keep the old hose or pipe to repair your future watering systems.
---------
The Bare Bones Gardener is a qualified Horticulturist and a qualified Disability Services Worker. He hates spending money on stuff which doesn’t live up to the promises given. So he looks for cheaper, easier, simpler or free ways of doing the same thing and then he passes these ideas on to others.
Garden Blog -
Tags: Garden, Garden Hose, Gardening, Hose, Polypipe
Loading ...